Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
i am using a Raspberry2 with I2C Repeater from Horter&Kalb.
There i connectet an AnalogInput Modul also from Horter&Kalb
Here is the problem:
I createt a new project in CFC only one input with the variable and the AnalogInput Modul is not working
I createt the same project in ST and i can`t belive my eyes the Modul works fine!
I am using the latest softwareversions.
Has anybody the same behavior??
Many thanks for your answers
Stefan
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello Everybody,
i am using a Raspberry2 with I2C Repeater from Horter&Kalb.
There i connectet an AnalogInput Modul also from Horter&Kalb
Here is the problem:
I createt a new project in CFC only one input with the variable and the AnalogInput Modul is not working
I createt the same project in ST and i can`t belive my eyes the Modul works fine!
I am using the latest softwareversions.
Has anybody the same behavior??
Many thanks for your answers
Stefan