Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I have make somthing with wago PLC (codesys 2.3) . I used a modbus I/O with 8 relay 12A out, 8 input, 1 comunication port 1 wire.
I need to do a modbus RTu comunication, so i ask you some informationa about some hardware to connect on raspberry:
1- Usb - rs485 conveyor (hal duplex comunication)
2- Enocean dongle and also library to codesys
3- ZigBee dongle and also library to codesys
4- Knx dongle and library comunication
we could make a post with all hardware that can be connected to rasperry and libraries CoDeSys. What do you think about it ??
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello,
i want to install codesys on rasberry.
We ask wich version of linux i need to install on the raspberry before to install codesys....
thanks
Ok: sorry i have read now that it's debian inside the program...
thanks
Hi,
yes and next steps are:
https://www.youtube.com/watch?v=6FPf3RHWyeU
BR
Edwin
Hello Edwin.
thank you very much for you replay.
I have look the video.
In my mind i want make a Home automation system.
I have make somthing with wago PLC (codesys 2.3) . I used a modbus I/O with 8 relay 12A out, 8 input, 1 comunication port 1 wire.
I need to do a modbus RTu comunication, so i ask you some informationa about some hardware to connect on raspberry:
1- Usb - rs485 conveyor (hal duplex comunication)
2- Enocean dongle and also library to codesys
3- ZigBee dongle and also library to codesys
4- Knx dongle and library comunication
we could make a post with all hardware that can be connected to rasperry and libraries CoDeSys. What do you think about it ??