Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
1-Is it possible File Conversion HEX to PRG ? by the CODESYS
2-I'm programming for truck cranes . truck cranes have a have several sensors (pressure sensor / length / angle, etc.)
NO PLC, NO WAGO ,NO ABB ,No nothing else ONLY PROGRAM WHIT CODESYS V2.3
How do I identify the software sensors CODESYS?
How should I define the ID of the sensor to the software? Software should go where?
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
1-Is it possible File Conversion HEX to PRG ? by the CODESYS
2-I'm programming for truck cranes . truck cranes have a have several sensors (pressure sensor / length / angle, etc.)
NO PLC, NO WAGO ,NO ABB ,No nothing else ONLY PROGRAM WHIT CODESYS V2.3
How do I identify the software sensors CODESYS?
How should I define the ID of the sensor to the software? Software should go where?