CODESYS - the IEC 61131-3 automation software
https://forum.codesys.com/

how can i integrate my own i2c device
https://forum.codesys.com/viewtopic.php?f=21&t=6054
Page 1 of 1

Author:  on4bhm [ Sun Feb 15, 2015 4:16 pm ]
Post subject:  how can i integrate my own i2c device

Hi,

Is it possible to integrate my own (not in the standard device included in the raspberry pi) i2c device
without using any aditional sofware?

Can someone explain how to do this?

kind regards

Author:  impius [ Mon Feb 16, 2015 1:37 pm ]
Post subject:  Re: how can i integrate my own i2c device

Hi on4bhm

I'm at the same point right now.
First thing you have to-do is to write your own devdesc.xml file.
Second is to create your own lib.
There is a sample on your local hard drive inside your user folder if you have installed the RaspberryPi package.
Also is a lib example in there.

Then Erikk uploaded his own devdesc.xml and a lib to run SHT-21 sensors (thanks again), see "Looking for library to run a SHT-1x sensor" discussion.
This may helps you to have an idea where to start.
Good luck, still working on my I2C-Device... and will upload it as soon as all is working.

Page 1 of 1 All times are UTC+01:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/