Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Hello,
is it possible to open the codesys webvisu with the ip?
i changed the port to 80, and now i can start the webvisu by entering "192.168.1.xxx/webvisu.htm" in the browser.
But i want to call it only by the IP. Any suggestions?
Best Regards
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello,
is it possible to open the codesys webvisu with the ip?
i changed the port to 80, and now i can start the webvisu by entering "192.168.1.xxx/webvisu.htm" in the browser.
But i want to call it only by the IP. Any suggestions?
Best Regards
Hello,
without a platforum in reach to try it myself, i guess changing "Name of .htm file:" into "index" should work.
Best Regards
Hello,
after testing with my PI, renaming into "index" is no solution.
Best Regards
it should be index.htm not just index