Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Hi all,
my problem is that the modbus does not work properly with the SP15, while it works well with the SP11.
With the SP11 I can read all the parameters, while with the SP15 I don't. To better explain the situation,
I have attached two images, where it can be seen that with the SP11 I can read all the modbus parameters,
while with the SP15 some yes and others not.
What can I do to solve the problem?
Thanks.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
If it's Modbus RTU you will not be able to use Wireshark. Not without a protocol converter anyway. Here is a tutorial about thatlook here. Honestly just google what you're looking for, there is quite a bit of information available on wireshark. It's a pretty standard tool for a few people that are trying to decode or troubleshoot network traffic.
Wireshark is...
Zitat:
Wireshark is an open source tool for profiling network traffic and analyzing packets. Such a tool is often referred to as a network analyzer, network protocol analyzer or sniffer.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi all,
my problem is that the modbus does not work properly with the SP15, while it works well with the SP11.
With the SP11 I can read all the parameters, while with the SP15 I don't. To better explain the situation,
I have attached two images, where it can be seen that with the SP11 I can read all the modbus parameters,
while with the SP15 some yes and others not.
What can I do to solve the problem?
Thanks.
NOTE: I am using CODESYS CONTROL FOR RASPBERRY PI SL V3.5.15.10 as runtime
Did you try to sniff the communication with Wireshark to better understand if there's some error into a slave channel?
Hi fleaplc, what is WIRESHARK?
If it's Modbus RTU you will not be able to use Wireshark. Not without a protocol converter anyway. Here is a tutorial about thatlook here. Honestly just google what you're looking for, there is quite a bit of information available on wireshark. It's a pretty standard tool for a few people that are trying to decode or troubleshoot network traffic.
Wireshark is...