Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Hello, I use a Pigeon RB350 PLC (raspberry compute inside).
I installed the license and it is visible in the license manager. But the runtime does not see it and starts in demo mode.
See attached file. [img]Licence.png[/img]
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
... guess there is a broken and a valid license in your system.
Broken - because used/applied on an other Raspberry PI
and then you activated the new license which is now valid but - we could only handle on SoftContainer.
Solution - > remove cmact_license directory restart the plc and apply the license again with the license backup file ( either from your CODESYS pc und
c:\ProgramData\CODESYS\Licenses\XXXXX-XXXXX-XXXXX-XXXXX-XXXXX or pull the CMLicenseNew.WibuCmRaU from the PI by CODESYS file browser.
BR
Edwin
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello, I use a Pigeon RB350 PLC (raspberry compute inside).
I installed the license and it is visible in the license manager. But the runtime does not see it and starts in demo mode.
See attached file.
[img]Licence.png[/img]
... guess there is a broken and a valid license in your system.
Broken - because used/applied on an other Raspberry PI
and then you activated the new license which is now valid but - we could only handle on SoftContainer.
Solution - > remove cmact_license directory restart the plc and apply the license again with the license backup file ( either from your CODESYS pc und
c:\ProgramData\CODESYS\Licenses\XXXXX-XXXXX-XXXXX-XXXXX-XXXXX or pull the CMLicenseNew.WibuCmRaU from the PI by CODESYS file browser.
BR
Edwin