CODESYS Forge - CODESYS Forge / Talk / Runtime 🇬🇧: CANbus Error

Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched. Close

CANbus Error

Forum: Runtime 🇬🇧

Creator: polygj

Created: 2018-01-21

Updated: 2018-01-22

polygj - 2018-01-21

If I don't enable the FB of MC_POWER , the axis is all right!
But when I enable the FB of MC_POWER, the axis is error.

I don't know the reason. Please help !

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

eschwellinger - 2018-01-22

Hi,
set the compiler define in the application properties:

CANOPEN_DEBUG

then download the project and check the plc logger for more details on These Problems on the CAN communication.

BR
Edwin

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

polygj - 2018-01-22

Thank you !

The servo error code is AL3E2 or AL3E3.

AL3E2: CANopen SYNC signal error
The CANopen SYNC signal is received too early.

AL3E3: CANopen SYNC timeout
The CANopen SYNC signal is not received within the specified time.

When I use LMC058 of Schneider in Somachine , the SYNC way is different.
They use the External signal. Can pi use this way?

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

eschwellinger - 2018-01-22

Hi,
from your screenshots your realtime should be good enough (maybe I'm wrong) but I would give this a try
to generate the sync on the Raspberry PI

BR
Edwin

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Log in to post a comment.