Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Hi Folks, haven't been here for a while but good to be back
I have a python script that is using Modbus to read data out of a PLC and publish it to a message queue using AMQT. I am using the PLC solely as a data collector reading input pulses and temperatures etc. If I got rid of the PLC hardware and replaced it with CODESYS running on the Pi, could I access the values in counters or normal registers in CODESYS from my python script?
Regards Simon
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi Folks, haven't been here for a while but good to be back
I have a python script that is using Modbus to read data out of a PLC and publish it to a message queue using AMQT. I am using the PLC solely as a data collector reading input pulses and temperatures etc. If I got rid of the PLC hardware and replaced it with CODESYS running on the Pi, could I access the values in counters or normal registers in CODESYS from my python script?
Regards Simon