Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Hi guys, I am new to this forum, trying to get raw CAN running on Raspberry 3B with PiCan2 hat using Codesys.
I have proved the PiCan2 board works well, I can send, read on RPI.
I have a problem get it from Codesys. Have downloaded CANbus example, updated Device to RPI, the ST example shows no error, but when online then driver had internal error. Is there anybody to help me please to get it running?
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi guys, I am new to this forum, trying to get raw CAN running on Raspberry 3B with PiCan2 hat using Codesys.
I have proved the PiCan2 board works well, I can send, read on RPI.
I have a problem get it from Codesys. Have downloaded CANbus example, updated Device to RPI, the ST example shows no error, but when online then driver had internal error. Is there anybody to help me please to get it running?
Hi,
hard to say,
all steps done to bring CAN up and running?
check several forum threads...
BR
Edwin