CODESYS - the IEC 61131-3 automation software

Welcome to the official CODESYS Forum by 3S-Smart Software Solutions GmbH | A member of the CODESYS Group
Deutsche Version English version russian version 
It is currently Thu Feb 27, 2020 6:44 pm

All times are UTC+01:00

Post new topic  Reply to topic  [ 1 post ] 
Author Message
PostPosted: Sat Aug 25, 2018 8:17 am 

Joined: Mon Aug 13, 2018 5:42 pm
Posts: 1
Good morning,

I am programming an IFM PLC, CR2532 communicating by CAN to a CR0451 panel.

I can not exchange the network variables between PLC and HMI.
The CAN wiring is correct because I can send code to the PLC and HMI from Codesys 2.3 and the "Maintenance" application from IFM.The wiring is according to the IFM manual "ecomatmobile", page 230.
Since IFM I have sent tutorials and information and even then, there has been no way to exchange a single variable.
The configuration that is currently in the installation is as follows:
PLC CR2532, ID: 126
HMI CR0451, ID: 1

The application I want to do is very simple, exchange bool variables from PLC to HMI, to see the status of inputs and outputs of the PLC, and from CR0451 to send bool variables, to select some options.

If someone has a tutorial or small program that works with this PLC-HMI and exchanges these variables, I would greatly appreciate it, since I am a bit blocked ...

Attached screenshots of the current application loaded to the PLC and HMI, of the network variable settings, etc.

You do not have the required permissions to view the files attached to this post.

Display posts from previous:  Sort by  
Post new topic  Reply to topic  [ 1 post ] 

All times are UTC+01:00

Who is online

Users browsing this forum: No registered users and 4 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Limited