Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched. Close

Wago plc communicate its IP Address

jardeneaux
2018-06-11
2018-06-19
  • jardeneaux - 2018-06-11

    Hello everyone i am new to the form.

    What I am trying to do is have my plc on bootup communicate to the pc it was plugged in to, via ethernet that's running Labview, its IP Address. So, that the pc can then open a Modbus TCP connection. I have been looking at Ethernet.lib from Wago and few other libraries, but i have not have had any luck. I am new to Labview and Codesys. So I am sorry if this a trivial question.

    Thanks

     
  • eschwellinger

    eschwellinger - 2018-06-19

    Hi,
    which plc are you using?
    Is this a PFC100 or PFC200.. 750-810x, 750-820x?
    Then I would chose CODESYS V3 and use OPCUA to communicate between Labview and CODESYS plc.
    (CODESYS OPCUA Server is embedded in the plc - Labview is OPCUA Client in this case)
    In CODESYS V2.3 this is not possible that way.
    You could try it, just install :
    https://store.codesys.com/catalogsearch ... /?q=PFC100
    in case you are using one of this Controller.

    BR
    Edwin

     

Log in to post a comment.