CODESYS - the IEC 61131-3 automation software

Welcome to the official CODESYS Forum by 3S-Smart Software Solutions GmbH | A member of the CODESYS Group
Deutsche Version English version russian version 
It is currently Tue Jan 28, 2020 6:51 pm

All times are UTC+01:00

Post new topic  Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Mon Jun 11, 2018 2:08 pm 

Joined: Fri Jun 08, 2018 10:56 pm
Posts: 1
Hello everyone i am new to the form.

What I am trying to do is have my plc on bootup communicate to the pc it was plugged in to, via ethernet that's running Labview, its IP Address. So, that the pc can then open a Modbus TCP connection. I have been looking at Ethernet.lib from Wago and few other libraries, but i have not have had any luck. I am new to Labview and Codesys. So I am sorry if this a trivial question.


PostPosted: Tue Jun 19, 2018 6:17 am 
Site Admin

Joined: Mon Sep 05, 2005 9:42 am
Posts: 3604
which plc are you using?
Is this a PFC100 or PFC200.. 750-810x, 750-820x?
Then I would chose CODESYS V3 and use OPCUA to communicate between Labview and CODESYS plc.
(CODESYS OPCUA Server is embedded in the plc - Labview is OPCUA Client in this case)
In CODESYS V2.3 this is not possible that way.
You could try it, just install : ... /?q=PFC100
in case you are using one of this Controller.


Display posts from previous:  Sort by  
Post new topic  Reply to topic  [ 2 posts ] 

All times are UTC+01:00

Who is online

Users browsing this forum: No registered users and 2 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Limited