Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I connected via CanBus and PCAN Ethernet an IFM Controller CR0401 with my PC succesfully.
I recieve Data from the Controller, but cant send anything.
During my research I found out that the IPEH-004010 is only supported by CodeSys v3.0 and higher?!? But the CR0401 works only with CodeSys v2.3.
But i wonder why i am able to recieve Data from the IFM? Maybe it is just a coincidence?
But maybe there is a solution to send commands to CodeSys v2.3 too?! Or do i really need another Controller which supports CodeSys v3.0?
Has anyone some experience?
Cheerz
joe
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hey!
I connected via CanBus and PCAN Ethernet an IFM Controller CR0401 with my PC succesfully.
I recieve Data from the Controller, but cant send anything.
During my research I found out that the IPEH-004010 is only supported by CodeSys v3.0 and higher?!? But the CR0401 works only with CodeSys v2.3.
But i wonder why i am able to recieve Data from the IFM? Maybe it is just a coincidence?
But maybe there is a solution to send commands to CodeSys v2.3 too?! Or do i really need another Controller which supports CodeSys v3.0?
Has anyone some experience?
Cheerz
joe