Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I'm new to codesys platform. I cannot use add block in LD, CFC. Output is enabled,, but the coil is not energized and output value is not reflected. Please guide me.
Thanks,
Arrvvii
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello guys,
I'm new to codesys platform. I cannot use add block in LD, CFC. Output is enabled,, but the coil is not energized and output value is not reflected. Please guide me.
Thanks,
Arrvvii
Originally created by: scott_cunningham
I believe you asked this question and solved it under the CoDeSys 3 board: l viewtopic.php?f=11&t=7964#p18476 l
are you running this prg in the task manager?