CODESYS - the IEC 61131-3 automation software
https://forum.codesys.com/

analog outputs ramp up time?
https://forum.codesys.com/viewtopic.php?f=2&t=7180
Page 1 of 1

Author:  gvanroey [ Thu Sep 01, 2016 7:29 am ]
Post subject:  analog outputs ramp up time?

Hi,

i have a program programmed in CoDeSys V2.3.
i have a problem with my analog output (%QW134).
it seems to have a ramp up time.
it starts at 0mA and go's slowly (+/- 3sec) up to te preconfigured value (stroom_kanaal_5 & 6).
i have a HMI screen on my system as wel where i can read my actual mA on the output and i can see from the moment i activate my input (logische_sturing_boren.boorkop_draaien_rechts_actief) the current starts at 0 and go's up to the preconfigured value between 200mA and 550mA. it takes like 3 sec.

i really need the proconfigured value immediatly on my output. is this programmable or it this rather a hardware problem?

regards,
Gvanroey

Author:  shooter [ Sun Sep 04, 2016 9:38 pm ]
Post subject:  Re: analog outputs ramp up time?

what type of module is connected to this %QW134?
and what is on analog_01 ?

for rest i do not trust DINT_to_WORD as the sign is lost so the MSB is not correct.

btw as i am also dutch you may email me in nederlands.

Page 1 of 1 All times are UTC+01:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/