CODESYS - the IEC 61131-3 automation software

Welcome to the official CODESYS Forum by 3S-Smart Software Solutions GmbH | A member of the CODESYS Group
Deutsche Version English version russian version 
It is currently Fri Nov 15, 2019 7:22 pm

All times are UTC+01:00

Post new topic  Reply to topic  [ 1 post ] 
Author Message
PostPosted: Wed May 11, 2016 8:46 pm 

Joined: Tue Nov 01, 2011 2:23 pm
Posts: 1
Hello everybody,
I need your help. Now I have project "runway car with JET motor"
and I need to use encoder for to know where is arm with motor.
I'm using ifm CR0403 PLC which is working without any troubles on all projects
but now I'm in a trap. PLC configuration contain setting by EDS file for components on the CAN bus.
Encoder is connected, status LED is blinking like OK but module doesn't work. My, for me important, question
sounds: How to correctly configure EDS file in PLC configuration? Because I don't know what does it mean
"write DCF", "creat all SDO's", "optional device",... Hot to correctly set device over PLC config for normal using of SDO?
What is necessary to switch on among posibilities: emergency telegram, heartbeat settings,... Which value must be there?
This is my trap. I must have project in couple of days done but encoder doesn't work. Output is UDINT.
Type of encoder is IFM RN7012.

If you can, please help me.

Thx, Zdenek

Display posts from previous:  Sort by  
Post new topic  Reply to topic  [ 1 post ] 

All times are UTC+01:00

Who is online

Users browsing this forum: No registered users and 4 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Limited