Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I'm using ACS355 abb and I should write for my thesis a really simple program for control, the first question is I would like to control speed for istance the address of reference speed is 101, how can I run the motor with a speed of 50e.g in one program without using the control block ACS3XX_COM_MOD_RTU or using with ST.
second question: is possible to control the torque like giving a value for torque and then the velocity is changing? thanks in advance
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
if you dont use the function block you will have to write a value to a secific variable and send this to the drive.
you need to look this up in the manual.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
hi,
I'm using ACS355 abb and I should write for my thesis a really simple program for control, the first question is I would like to control speed for istance the address of reference speed is 101, how can I run the motor with a speed of 50e.g in one program without using the control block ACS3XX_COM_MOD_RTU or using with ST.
second question: is possible to control the torque like giving a value for torque and then the velocity is changing? thanks in advance
if you dont use the function block you will have to write a value to a secific variable and send this to the drive.
you need to look this up in the manual.