Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Good morning,
I've built my home with a domotic system based to a Wago 750-871 CPU and developed with codesys 2.3.9.43
Yesterday the program have crash and after restart I cannot open again my project, the message is "Could not open project/library (no valid project/library file).
I haven't backup projects (me damned) and now I'm desperate because this project had taken a lot of my time for the development ;(
What I can try to do?
Please, someone help me.
If someone need the project I can send by mail, ask to me.
Thank you very much, have a nice day to all.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Good morning,
I've built my home with a domotic system based to a Wago 750-871 CPU and developed with codesys 2.3.9.43
Yesterday the program have crash and after restart I cannot open again my project, the message is "Could not open project/library (no valid project/library file).
I haven't backup projects (me damned) and now I'm desperate because this project had taken a lot of my time for the development ;(
What I can try to do?
Please, someone help me.
If someone need the project I can send by mail, ask to me.
Thank you very much, have a nice day to all.
send it over to me, and i will have a look.
no backup, is a shame.
i always put it on a sticky.
Thank you very much, I've sent to you a .rar file
Yes, I know, is stupid not have a backup copy now I've learn the lesson...