Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Hi, I am a newbie (not in plc), but have some questions about CodeSys;
Are there methods/files for importing different types of controller makes into the CodeSys
editor out of those included in the default downloaded programming-tool? Are they to be found
with the manufacturer if?
Any way of importing/convert binary machine code direct from file? (instead of being uploaded)
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
controller types are called targets and should be available at the manufacturer, as codesys is a piece of software development used by many companies building PLC or controller it even exists for a RPi.
yes it is possible to include binaries in the code, however it is in V2.3 not easy, in V3 it is better documented, also C can be used.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi, I am a newbie (not in plc), but have some questions about CodeSys;
Are there methods/files for importing different types of controller makes into the CodeSys
editor out of those included in the default downloaded programming-tool? Are they to be found
with the manufacturer if?
Any way of importing/convert binary machine code direct from file? (instead of being uploaded)
controller types are called targets and should be available at the manufacturer, as codesys is a piece of software development used by many companies building PLC or controller it even exists for a RPi.
yes it is possible to include binaries in the code, however it is in V2.3 not easy, in V3 it is better documented, also C can be used.