Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
a safetyshutdown is possible by using a ladder with:
markeroutput AND running > realoutput (%QX0.0) etc
in all other programs use this markeroutput.
to get safety outputs you will need real safety modiules, or the supply to these outputs needs to come from a safetyrelias.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Is there a quick way of resetting all outputs on the PLC? I am using a Wago system.
a safetyshutdown is possible by using a ladder with:
markeroutput AND running > realoutput (%QX0.0) etc
in all other programs use this markeroutput.
to get safety outputs you will need real safety modiules, or the supply to these outputs needs to come from a safetyrelias.