Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I have an XC-CPU201 and i want to send/recive commands from other devices all connected in the same network (having TCP IP support) using TCP IP. Exactly when i have a "1" on a digital input (in my plc), the PLC needs to send a start command (send a bit) using TCP IP to a device from the network which address it's for example 192.168.1.x.
Can someone help me with a blueprint to achieve that?
Thank you!
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I have an XC-CPU201 and i want to send/recive commands from other devices all connected in the same network (having TCP IP support) using TCP IP. Exactly when i have a "1" on a digital input (in my plc), the PLC needs to send a start command (send a bit) using TCP IP to a device from the network which address it's for example 192.168.1.x.
Can someone help me with a blueprint to achieve that?
Thank you!
Hello,
Have a look to the application note "AN2700K33.zip" you can get here :
ftp://ftp.moeller.net/AUTOMATION/DOWNLO ... ERNET/FTP/
In this application note there are : libraries (TCPClient and TCP Server), an example of programme (export file) and a documentation (pdf).
Best regards
Thank you very much!