Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I'm wondering if anyone knows where you can put global variables and not, and where the CANopen USB to CAN is.
I also found a picture that says SDOs are from 580h to 680h.
I've had problems to log in to some modules (IFM CR0403). (And using CANfox EC2112)
When I used a CAN Monitor on another computer i found "ID hex" [5E4] and [664] and the Boolean variable [A] that i forced true and false.
what i monitor is basically: 5E4 --> 664 --> 5E4 (see picture).
Sendarix
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello,
I'm wondering if anyone knows where you can put global variables and not, and where the CANopen USB to CAN is.
I also found a picture that says SDOs are from 580h to 680h.
I've had problems to log in to some modules (IFM CR0403). (And using CANfox EC2112)
When I used a CAN Monitor on another computer i found "ID hex" [5E4] and [664] and the Boolean variable [A] that i forced true and false.
what i monitor is basically: 5E4 --> 664 --> 5E4 (see picture).
Sendarix