Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
This being me first post on a forum, please bear with me. I have recently been dropped in the deep end with PLC programming and encountered my first real issue while attempting to make a WAGO 750-841 module "talk" to an Allen-Bradley Logix5562 module:
Short remark. The compiler is complaining about the network_path not the tag.
Usually the any IP adresses are written in string format. And you have not what I can see.
Try to make the adress as string by, adding ' '. Like '127.0.0.1'. Or make a variable as string.
/Torbjörn
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi there
This being me first post on a forum, please bear with me. I have recently been dropped in the deep end with PLC programming and encountered my first real issue while attempting to make a WAGO 750-841 module "talk" to an Allen-Bradley Logix5562 module:
I followed this guide: http://www.wago.com/wagoweb/documentation/app_note/a2032/a203200e.pdf
http://www.wago.com/wagoweb/documentation/app_note/a2030/a203000e.pdf where on page 12 there is a screenshot similar to the one in the guide I followed, with the same function block inputs left blank. BUT on page 17 of http://www.wago.com/wagoweb/documentation/app_note/a2036/a203600e.pdf
I would really like to know what I am doing wrong, or at least advice on where to find information to educate myself enough to figure it out myself.
Cheers,
Stef
Hi!
Short remark. The compiler is complaining about the network_path not the tag.
Usually the any IP adresses are written in string format. And you have not what I can see.
Try to make the adress as string by, adding ' '. Like '127.0.0.1'. Or make a variable as string.
/Torbjörn
Hi,
Thank you Torbjörn, that sorted it out! Rookie error on my part
Cheers,
Stef