CODESYS - the IEC 61131-3 automation software

Connecting to PLC via serial cable / usb
Page 1 of 1

Author:  iamnotarobot [ Wed Nov 06, 2019 10:33 am ]
Post subject:  Connecting to PLC via serial cable / usb

Hello. I am trying to connect to a Moeller XN-PLC via usb > com > ps2. Driver seems to be installed correctly. What i am struggling with are communication parameters. It tries to connect for a while but then give communication error logged out. Any tips on what i am doing wrong?

1 Open.PNG

2 Target settings.PNG

3 Communication parameters.PNG

4 Device settings.PNG

Page 1 of 1 All times are UTC+01:00
Powered by phpBB® Forum Software © phpBB Limited