Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched. Close

Possibility to scan for EtherCAT (CANopen,...) devices ?

PLKM
2017-07-13
2017-07-13
  • PLKM - 2017-07-13

    Is there any possibility to scan for devices like the GUI command ("Geräte suchen") for a fieldbus?

    As alternative there is a command available "Geräte suchen" in system.commands. Is there any information about the 2 parameters device and scan for this command ?

     
  • mkeller - 2017-07-13

    Hi PLKM.

    PLKM hat geschrieben:
    Is there any possibility to scan for devices like the GUI command ("Geräte suchen") for a fieldbus?
    As alternative there is a command available "Geräte suchen" in system.commands. Is there any information about the 2 parameters device and scan for this command ?

    If it is the command with the GUID "73B2CA6F-8B4E-45cb-9533-EAA108AAF7F7", it has an non-interactive mode which would execute the scan on a device which is selected in the Devices view. The problem is that you can't selected an object in the Navigator views through Scripting.

    BR
    Martin

     

Log in to post a comment.