I wish to write/select value into a "Value" field such as Off, -10V to 10V, -150mV to 150mV & etc under Module Configuration(Kindly refer to screenshot below), what would the correct scripting command?
The functionality to configure device parameters via Scripting was implemented for the issue CDS-22506
which will be released with V3.5 SP4 (currently scheduled for December).
As a side note, the Test Manager already has device parameter configuration functionality.
In future, how would I know which is correct command to use for other purpose I need to use as there is alot of scripting commands in the scripting command help.
Reading the help file should be the easiest way to find out what purpose those commands fulfil.
Check out the CODESYS store: http://store.codesys.com/CODESYS® a trademark of 3S-Smart Software Solutions GmbH
Inspiring Automation Solutions