Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Hello, I am trying to get a test rig which tests different protocols. I know the Raspberry Pi supports ProfiNet. But I have been asked to use the Siemens PLC to control the device under test.
My thought was to setup an OPC server on the Siemens PLC and a OPC client on the Raspberry Pi. All I can find is a Codesys OPC server for Raspberry Pi. The Siemens PLC OPC software is server only.
Could two OPC servers talk to each other? I have installed a OPC client on the Raspberry Pi, which can access the Codesys OPC server on the localhost.
Snap7 wouldn't install, so gave up on that.
Thanks
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
In the future a client will be included. I found in the Siemens forum that it may be included in V15 of their Tia portal. But Siemens' website doesn't say that at all.
Thanks
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello, I am trying to get a test rig which tests different protocols. I know the Raspberry Pi supports ProfiNet. But I have been asked to use the Siemens PLC to control the device under test.
My thought was to setup an OPC server on the Siemens PLC and a OPC client on the Raspberry Pi. All I can find is a Codesys OPC server for Raspberry Pi. The Siemens PLC OPC software is server only.
Could two OPC servers talk to each other? I have installed a OPC client on the Raspberry Pi, which can access the Codesys OPC server on the localhost.
Snap7 wouldn't install, so gave up on that.
Thanks
Hi,
using OPC UA Server on Raspberry PI...
Is it possible to have a OPCUA CLient on siemens side?
BR
Edwin
It says here
https://w3.siemens.com/mcms/automation- ... fault.aspx
In the future a client will be included. I found in the Siemens forum that it may be included in V15 of their Tia portal. But Siemens' website doesn't say that at all.
Thanks