Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Hi,
this is my first time working with CODESYS Environment as well as communicating using OPC.
I have a project to connect a PLC to a plant simulation software which only supports OPC DA, so I downloaded and installed CODESYS OPC DA Server SL Demo software from the store.
As I understood, I need to configure the DCOM settings on my Windows to make the connection works, and according to the FAQ ( l viewtopic.php?f=22&t=5649&p=10047#p10047 l ), there should be an item called OPC Server for CoDeSys V2.0 or CoDeSys OPCServer DA under the DCOM settings but I cannot find them in my computer.
Any ideas on how to set it up with CODESYS V3?
Also, any suggestions regarding DA communications will be much appreciated.
Regards,
Setyadi
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi,
this is my first time working with CODESYS Environment as well as communicating using OPC.
I have a project to connect a PLC to a plant simulation software which only supports OPC DA, so I downloaded and installed CODESYS OPC DA Server SL Demo software from the store.
As I understood, I need to configure the DCOM settings on my Windows to make the connection works, and according to the FAQ ( l viewtopic.php?f=22&t=5649&p=10047#p10047 l ), there should be an item called OPC Server for CoDeSys V2.0 or CoDeSys OPCServer DA under the DCOM settings but I cannot find them in my computer.
Any ideas on how to set it up with CODESYS V3?
Also, any suggestions regarding DA communications will be much appreciated.
Regards,
Setyadi