Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched. Close

OPC client with CODESYS

Anonymous
2014-07-09
2014-10-17
  • Anonymous - 2014-07-09

    Originally created by: henrie@brinkbv.com

    Hi,

    Is it possible to read data from a OPC server, with a CODESYS V2.3 PLC (Eaton XV panel)?
    The OPC server uses the OPC XML DA protocol.

    If that is not possible, what is a good solution to read this data?

    Regards,

    Henrie

     
  • r.kunz - 2014-07-11

    Hello Henrie

    If OPC XML DA is supported or not -I don't know... Sorry!

    But from WHERE are you going to read data from the PLC? Is there a management system a level higher?
    Maybe the easier way is to write date from the PLC to anywhere..., e.g. into a database, file,....

    Roger

     
  • Anonymous - 2014-07-14

    Originally created by: henrie@brinkbv.com

    Hello Roger,

    Thanks for the replay.

    It is an existing system, were I need to modify some variables by the OPC connection.
    I can not do anything on the existing system.
    I was thinking the Eaton XV panel is running on Win CE 5.
    Is there maybe a OPC client software for Wince5, where codesys the data read from?

    Regards,

    Henrie

     
  • shooter - 2014-10-17

    yes contact codesys they do have this as a separate option.

     

Log in to post a comment.