Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I am using PLC Designer (Lenze) v 3.19.0.12851. I have been testing a program all week. Yesterday after going online with the simulator, Many of the debug buttons became grayed-out. Step Over, Step Into, Step Out, Run to Cursor, Set Next Statement, and Show Next Statement are no longer active. I uninstalled and reinstalled, but that has no effect. Any suggestions to get these buttons working again?
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I am using PLC Designer (Lenze) v 3.19.0.12851. I have been testing a program all week. Yesterday after going online with the simulator, Many of the debug buttons became grayed-out. Step Over, Step Into, Step Out, Run to Cursor, Set Next Statement, and Show Next Statement are no longer active. I uninstalled and reinstalled, but that has no effect. Any suggestions to get these buttons working again?