Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
When you try to login, you login to the PLC whose application is in bold caracters.
So, before login to the other PLC, you must put the name of the application in bold caracters.
For that : Select the application then, with a right clic, select "Set Active Application". The application is now in bold caracters.
Then you can login to the correct PLC.
BR
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
In the help it wasn't that clear as the section describing having several devices didn't say how to login to one of them and the section about login talked about applications..
But now it works. Thanks for replying.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I want to have 2 PLCs in the same project.
So I tried to put them there. No problem.
Then i setup the communication settings. OK here aswell both PLCs accessible.
But when i want to Login I can only login the PLC at the top. What am I doing wrong?
When you try to login, you login to the PLC whose application is in bold caracters.
So, before login to the other PLC, you must put the name of the application in bold caracters.
For that : Select the application then, with a right clic, select "Set Active Application". The application is now in bold caracters.
Then you can login to the correct PLC.
BR
Yes I found it to..
In the help it wasn't that clear as the section describing having several devices didn't say how to login to one of them and the section about login talked about applications..
But now it works. Thanks for replying.