Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I have a wago plc 750-8202 that i would like to replace by a wago 750-8212. therefore i need to be able to save my current values of my persistent vars to my pc or sd card so i can upload them to the new controller. i tried too do this with the SysPlcCtrl23 lib. by using the SysSaveRetains function. i stored the file to the flash of the controller and then tried to open it by accessing the file with an ftp connection. when i open the file, it gives me all kinds of symbols but not the values i see in the program. i tried to restore the values back to the controller but it doesn't seem to do anything.
anybody an idea how i can extract the actual values of the persitent vars to my pc and then load therm in to my new controller?
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I have a wago plc 750-8202 that i would like to replace by a wago 750-8212. therefore i need to be able to save my current values of my persistent vars to my pc or sd card so i can upload them to the new controller. i tried too do this with the SysPlcCtrl23 lib. by using the SysSaveRetains function. i stored the file to the flash of the controller and then tried to open it by accessing the file with an ftp connection. when i open the file, it gives me all kinds of symbols but not the values i see in the program. i tried to restore the values back to the controller but it doesn't seem to do anything.
anybody an idea how i can extract the actual values of the persitent vars to my pc and then load therm in to my new controller?