Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched. Close

Symbol Configuration

reimber
2019-02-14
2019-02-14
  • reimber - 2019-02-14

    Hi All,

    I have set up a symbol configuration which happily picks up all the variables both local and global as I would expect.

    However I have a Structure(DUT) that I would like to pass into the symbol table and then later on over the comms to my HMI.

    Is this possible ?

    My symbol configuration does not pick up the structure(DUT).#

    Thanks for taking a look at this hope to here from you soon.

    Cheers

     
  • reimber - 2019-02-14

    Hi All,

    Found the issue, I had created the Structure(DUT) but forgot to create an instance of it therefore I wasn't seeing the Structure.

    Hope this helps anyone else.

    Thanks for viewing

     

Log in to post a comment.