CODESYS - the IEC 61131-3 automation software

Welcome to the official CODESYS Forum by 3S-Smart Software Solutions GmbH | A member of the CODESYS Group
Deutsche Version English version russian version 
It is currently Sat Sep 21, 2019 9:51 am

All times are UTC+01:00




Post new topic  Reply to topic  [ 2 posts ] 
Author Message
 Post subject: Symbol Configuration
PostPosted: Thu Feb 14, 2019 9:56 am 
Offline

Joined: Sat Aug 27, 2016 11:39 pm
Posts: 6
Hi All,

I have set up a symbol configuration which happily picks up all the variables both local and global as I would expect.

However I have a Structure(DUT) that I would like to pass into the symbol table and then later on over the comms to my HMI.

Is this possible ?

My symbol configuration does not pick up the structure(DUT).#

Thanks for taking a look at this hope to here from you soon.

Cheers

:D


Top
   
 Post subject: Re: Symbol Configuration
PostPosted: Thu Feb 14, 2019 10:39 am 
Offline

Joined: Sat Aug 27, 2016 11:39 pm
Posts: 6
Hi All,

Found the issue, I had created the Structure(DUT) but forgot to create an instance of it therefore I wasn't seeing the Structure.

Hope this helps anyone else.

Thanks for viewing

:oops:


Top
   
Display posts from previous:  Sort by  
Post new topic  Reply to topic  [ 2 posts ] 

All times are UTC+01:00


Who is online

Users browsing this forum: No registered users and 7 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Limited