Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched. Close

methods in OPC UA Information model for IEC61131-3

alb123
2019-01-11
2020-11-09
  • alb123 - 2019-01-11

    Hi all

    While making some tests with OPC UA on a wago PFC100 I found that my function block methods and properties where not available from the opc client (UAexpert)

    This led me to having a look at the PLCopen and OPC foundation "OPC UA Information model for IEC61131-3".
    I can not find any information regarding IEC61131-3 methods.
    It seems obvious that function block methods should be mapped to OPC UA methods, so that when exposing ie. a motor object(FB) with start() and stop() methods, these methods are available from the opc client.

    Am I missing something?

     
  • rombo130 - 2020-11-09

    Up

     

Log in to post a comment.