CODESYS - the IEC 61131-3 automation software
https://forum.codesys.com/

Adding "modules" to GSDML
https://forum.codesys.com/viewtopic.php?f=11&t=9305
Page 1 of 1

Author:  tsimpson [ Wed Nov 14, 2018 5:55 pm ]
Post subject:  Adding "modules" to GSDML

Greetings,

Can someone tell me if it is possible to, as a user, add modules to the Profinet GSDML?

The case is this, I am using a Pi as an IO simulator with an S7-1500 over Profinet. Problem is I would like to have more module choices than "x 8bit", "x Float32", etc. I can see where I could edit the GSDML after creation, but that would only be applicable to the S7-1500 side (as I see it).

I would like to add something like "x Word16", and "x Int16" for example (on both sides of course). Is this even possible or is my only option to use what is available as default?

Author:  tsimpson [ Thu Nov 29, 2018 9:51 pm ]
Post subject:  Re: Adding "modules" to GSDML

I see there has been a lot of views. Is this just something that cannot be changed, or does nobody know?

Page 1 of 1 All times are UTC+01:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/