Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched. Close

IecVarAccess

WagoGrim
2018-11-09
2018-11-15
  • WagoGrim - 2018-11-09

    Hi folks,

    Do anyone have example of using the "IecVarAccess" library ? Did some testing but could not figure this out !
    Want to read/write the "Symbol Configuration". If it works it's maybe possible to manipulte the published OPCUA variables in run-time (?).

    Thanks,

     
  • dFx

    dFx - 2018-11-14

    To be confirmed by some admin, but to me, OPC UA server is in general configured by a config file at startup, so you would also have to control your OPC UA and correctly place the file in the PLC filesystem.

     
  • WagoGrim - 2018-11-15

    dFx hat geschrieben:
    To be confirmed by some admin, but to me, OPC UA server is in general configured by a config file at startup, so you would also have to control your OPC UA and correctly place the file in the PLC filesystem.

    Yes it may be as you describe. But it would anyway be nice to work with the IecVarAccess library! Thanks.

     

Log in to post a comment.