Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I am currently trying to connect to the control unit of a G120 kit
While experimenting around, I found that the bare Profinet device provided by Codesys is showing the exact same behaviour. I would therefore conclude that this is entirely unrelated to the imported GSDML files. I first observed this in v3.5 SP13 and could reproduce it in the recently released v3.5 SP13p1. Any advice?
TIA!
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello,
I am currently trying to connect to the control unit of a G120 kit
While experimenting around, I found that the bare Profinet device provided by Codesys is showing the exact same behaviour. I would therefore conclude that this is entirely unrelated to the imported GSDML files. I first observed this in v3.5 SP13 and could reproduce it in the recently released v3.5 SP13p1. Any advice?
TIA!
Hi,
for me it should like an bug on CODESYS side.
We try to fix it for next Version.
BR
Edwin