Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I have some bus devices like Beckhoff EL3058 and EL4004, where I am able to export the Startup Parameters to a XML list, and I can confirm that the file actually have the list.
But when trying to import, it silently fails. No parameters come on the list, and no error message shows up.
On the other hand, I have tried to do the same in a CoE device (eg AX5112), and there the import XML list works fine.
This is on Codesys 3.5.12.40.
Thanks!
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I have some bus devices like Beckhoff EL3058 and EL4004, where I am able to export the Startup Parameters to a XML list, and I can confirm that the file actually have the list.
But when trying to import, it silently fails. No parameters come on the list, and no error message shows up.
On the other hand, I have tried to do the same in a CoE device (eg AX5112), and there the import XML list works fine.
This is on Codesys 3.5.12.40.
Thanks!