Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Hi, i am working on the canopen with codesys. I get a very strange observation, instead of sending the start signal to the otb (slave), with a canopen sniffer, i can see two reset signal in a very short time after the init phase to the otb. Only one otb is considered. And the process repeats, the otb never enters into the working state. Please see the attached file, the red line is a reset signal (Capture3.PNG). It should be a "start".
Any information is highly appricieated. Thanks
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi, i am working on the canopen with codesys. I get a very strange observation, instead of sending the start signal to the otb (slave), with a canopen sniffer, i can see two reset signal in a very short time after the init phase to the otb. Only one otb is considered. And the process repeats, the otb never enters into the working state. Please see the attached file, the red line is a reset signal (Capture3.PNG). It should be a "start".
Any information is highly appricieated. Thanks
Hi,
which plc in which version are you using?
BR
Edwin