Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
i am currently using CodeSys V3.5 SP12 to program my PLC (CTI 100.UTMS.C).
I would like to read some measured values from a JSON-File by my PLC-Controller through "JSON Utilities" libray.
Could i uplaod the JSON-File from HTTP-URL directly on the 'JSONData' function block and then be able to read these values from the URL direclty not from saved file?
Thanks a lot for your help !
hanels
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello every one,
i am currently using CodeSys V3.5 SP12 to program my PLC (CTI 100.UTMS.C).
I would like to read some measured values from a JSON-File by my PLC-Controller through "JSON Utilities" libray.
Could i uplaod the JSON-File from HTTP-URL directly on the 'JSONData' function block and then be able to read these values from the URL direclty not from saved file?
Thanks a lot for your help !
hanels