Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Good day to everyone.
I want to download the frequency inverter parameters via CANopen SDO function during pre-operational state,the frequency inverter parameters including acceleration time, deceleration time,frequency reference...
MY question is :
is it possible to save those parameters into a file(e.g. DataObject.csv), and this CSV file(or any other format file) can be added into project tree(See attached photo), then read the parameters via function block (e.g.SysFileRead)?
Thanks.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Good day to everyone.
I want to download the frequency inverter parameters via CANopen SDO function during pre-operational state,the frequency inverter parameters including acceleration time, deceleration time,frequency reference...
MY question is :
is it possible to save those parameters into a file(e.g. DataObject.csv), and this CSV file(or any other format file) can be added into project tree(See attached photo), then read the parameters via function block (e.g.SysFileRead)?
Thanks.