Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched. Close

Wago 750-632 proportional valve module

Engineering 🇬🇧
Mjbbru
2018-03-27
2018-04-03

  • Mjbbru - 2018-03-27

    Hi all,

    Can anyone tell me how to configure a Wago 750-632 module for 2 valve operation?

    The manual (http://www.wago.mx/download.esm?file=%5 ... xx_0en.pdf) says that I need 12 bytes to achieve that but my valve configuration shows only 6.

    I'm using the Wago 750-632 and several other cards on a PFC200.

    Thanks in advance.

     

  • eschwellinger

    eschwellinger - 2018-03-28

    Hi,
    could you please ask this question in the CODESYS store,
    'my question' an adapted device description is needed.

    BR
    Edwin

    IMG: 12B.jpg

    IMG: 632.jpg

     

  • somlioy - 2018-03-28

    Use Wago I/O Check to configure wether its 1 or 2 coils among other things.

     

  • Mjbbru - 2018-04-03

    Thanks for the replies.

    @Edwin
    I've asked this in the CODESYS store and they sent me a editted XML file.

    somlioy hat geschrieben:
    Use Wago I/O Check to configure wether its 1 or 2 coils among other things.

    I think these cards are configured for two valves out of the box. (I checked this with I/O Check)

     

Log in to post a comment.