Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I'm working with a Schneider PLC: TM218LDA24DRN. So Machine 3.1 (Codesys 3.1) is used for programming.
I would like to know whether it is possible to retrieve the PLC program from internal memory (or memory card, in case of other models).
For example: Let's say, I've been tasked to modify an application that is controlled by a Schneider PLC. I don't have the program on hand. Instead of recreating the program or writing one from scratch, I would like to retrieve/ import the program from PLC memory to So Machine 3.1, modify the program, and download to PLC.
Is something like this possible?
Thank you.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello,
I'm working with a Schneider PLC: TM218LDA24DRN. So Machine 3.1 (Codesys 3.1) is used for programming.
I would like to know whether it is possible to retrieve the PLC program from internal memory (or memory card, in case of other models).
For example: Let's say, I've been tasked to modify an application that is controlled by a Schneider PLC. I don't have the program on hand. Instead of recreating the program or writing one from scratch, I would like to retrieve/ import the program from PLC memory to So Machine 3.1, modify the program, and download to PLC.
Is something like this possible?
Thank you.