Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I want to know if it is possible to adjust user parameters (station parameters) with a codesys program.
Now we need to set the parameters and load it into the PLC (which gives a short down-time).
Now i want to change the parameters by selecting a value onto a touchscreen. For this i need to get to the right parameter and i don't know if this can be done in Codesys or not.
Thanks in advance.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi all,
I want to know if it is possible to adjust user parameters (station parameters) with a codesys program.
Now we need to set the parameters and load it into the PLC (which gives a short down-time).
Now i want to change the parameters by selecting a value onto a touchscreen. For this i need to get to the right parameter and i don't know if this can be done in Codesys or not.
Thanks in advance.
Could you elaborate on what kind of parameters you mean?