Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I have a question regarding Ethercat configuration. Is it possible to select active Module connected to an Ethercat Slave at Runtime?
For example if I have an Ethercat Slave and this Slave consists of 2 Digital Input Modules and 2 Digital Output Moduls and I would like to deselect the second Output Module at Runtime.
Is that Possible?
Kind Regards
Stefan
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello,
I have a question regarding Ethercat configuration. Is it possible to select active Module connected to an Ethercat Slave at Runtime?
For example if I have an Ethercat Slave and this Slave consists of 2 Digital Input Modules and 2 Digital Output Moduls and I would like to deselect the second Output Module at Runtime.
Is that Possible?
Kind Regards
Stefan