Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I've understood that each bus task cycle one channel is read/written. But there also seem to be a limitation on the channel length (ie. the number of registers to read)? Is that correct or do I have a problem with my Modbus slave...?
Best Regards,
Johan
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi,
I've understood that each bus task cycle one channel is read/written. But there also seem to be a limitation on the channel length (ie. the number of registers to read)? Is that correct or do I have a problem with my Modbus slave...?
Best Regards,
Johan