Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I'm looking for documentation on the "Application" trigger type for the Modbus RTU write function. Both the library documentation and the online help only mentions the "Cyclic" and "Rising edge" types.
Best Regards,
Johan
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Edwin Schwellinger hat geschrieben:
Hi,
this is a configuration on the channels... https://help.codesys.com/webapp/mod-edt ... n=3.5.11.0
Additional since SP11 you could use the Modbuschannel fb which you could use by your application code.
BR
Edwin
Hello Edwin,
This is what I'm trying to work out, too. How do I use the modbuschannel fb to trigger the channel?
Kind Regards
Heinz
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi,
I'm looking for documentation on the "Application" trigger type for the Modbus RTU write function. Both the library documentation and the online help only mentions the "Cyclic" and "Rising edge" types.
Best Regards,
Johan
Hi,
this is a configuration on the channels...
https://help.codesys.com/webapp/mod-edt ... n=3.5.11.0
Additional since SP11 you could use the Modbuschannel fb which you could use by your application code.
BR
Edwin
Hello Edwin,
This is what I'm trying to work out, too. How do I use the modbuschannel fb to trigger the channel?
Kind Regards
Heinz