Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I have a simple ladder program, which compiles with no errors.
however when running the simulation mode, the program is in RUN state is green the logic does not operate.
i.e. the left hand side of the ladder rung is blue, when I activate a switch to TRUE nothing happens.
please see attached screen shot.
many thanks.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I have a simple ladder program, which compiles with no errors.
however when running the simulation mode, the program is in RUN state is green the logic does not operate.
i.e. the left hand side of the ladder rung is blue, when I activate a switch to TRUE nothing happens.
please see attached screen shot.
many thanks.
Press F7
Thanks, all good.
Prefer to use ctrl + f7
You could have a bad joke with a hard forcing